How to Set Up Link Aggregation on the Nighthawk X10 Router and S8000 Switch | NETGEAR

Skip ad
9 Views

  • Thanks! Share it with your friends!

    You disliked this video. Thanks for the feedback!

netgear
Published
Learn more about the NETGEAR Nighthawk X10 and S8000 here: http://bit.ly/2aQXlVd

Watch this quick video to learn how to setup link aggregation on the NETGEAR Nighthawk X10 WiFi Router and the Nighthawk S8000 Gaming and Streaming Switch.

Link aggregation (LAG) between two networking devices can allow you to combine multiple Ethernet connections to double your connection bandwidth. In order to setup link aggregation on your Nighthawk WiFi Router and Switch, you must create a link aggregation group (LAG) on both of these devices.

Follow these high-level steps to set up link aggregation:

First, disconnect your Nighthawk switch from your Nighthawk X10 router. Make sure that your Nighthawk switch’s port speed, duplex mode, flow control, port priority, and port-based rate limiting settings are correct. Now, set up a LAG on your Nighthawk switch. Set up a LAG on your Nighthawk X10 router. Then, connect the ports that you made members of a LAG on the switch to ports 1 and 2 on your Nighthawk X10 router.

For more detailed written instructions, please follow these steps: http://bit.ly/2nBepTY

Be sure to subscribe for more videos: http://bit.ly/1JsK6Ej
Category
Netgear
Tags
NETGEAR, Nighthawk, X10
Be the first to comment